Welcome to K.R.System
K.R.Systems was promoted with the aim to provide professional automatic water level controllers using simple, reliable technology and also to suit various type of motors and pumps. Our products are certified and approved by ISO 9001:2015, CE, National test house (NTH), PWD & SSI.
5 keys of saveon
> PROTECTING MOTORS AND PUMPS – DRY RUN PROTECTION
One of the special features in our SAVEON product is Dry run protection. This helps your water pump getting damaged by working, while the sump is empty or there will be no ground water or the water pipe is blocked anywhere or when airlock occurs.
> SAVE WATER
Save water by avoiding the tank getting overflow, through SAVEON automatic ON & OFF operation depending on the adjustable Low & High level sensors.
> SAVE ELECTRICITY
Save electricity by avoiding unnecessary motor operation even after the over-head tank is full or the sump is empty.
> SAVE MONEY
Save money by saving water and electricity.
> SAVE VALUABLE TIME
Save your valuable time by switching the motor ON and OFF automatically depending on the Low & High level sensors inside the overhead tank (OHT).
We provide turnkey solution to control large number of tanks with single motor by using electrical operated gate valves (solenoid valves) during our installation.
- Any Automatic Water Level Controllers (AWLC) shall basically work to start the pump automatically as soon as the water level falls below the predetermined level and stops the same after reaching the overflow level.
- SAVEON provides you the flexibility to choose the water level controllers from a wide of products for the required operations. SAVEON helps to save a lot of electricity and water through its fully automatic feature. SAVEON as an automatic water level sensing and controlling system can be used in all aquatic environments.
- Key components of SAVEON includes, indicators, sensors, electrical installation and cabling.
- SAVEON is technically designed to suit motors of up to 1.5HP for single phase and for motors more than 1.5HP with an additional external contactor. But the 3 Phase motors with any capacity from 0.5HP to 90HP is adoptable to any motor like Mono Block Pump - Sump Motor, Submersible Pumps and Jet Pumps, Compressor, etc.,
SAVEON INDICATORS & BUZZER
- Fit for any type of Tanks (Cement / Sintex)
- Fit for any type of Pumps with any HP (Direct & Indirect drive possible)
- Fit for single phase Bore Pumps without dry run protection
- Fit for Bore Pumps and Open well submersible Pumps with switch control
- Fit for Pressure Booster Pumps
- Fit for Solenoid valves
- Fit for submersible pumps
- Fit for Sump Pumps
- Fit for any type of Pumps including compressor pumps with any HP
(Direct & Indirect drive possible)
- DRP - Dry Run Protection
- Motor will switch off automatically if water is not pouring in OHT tank after 30 seconds.
- Additional special features: Motor will switch on automatically after 1 hour as and when ground water level improves.
- SP – Shock Proof
- Since sensing is done using very Low Voltage High Frequency signal no worry about electrical shocks and specially designed split bobbin used in Transformer.
- SS – Soft Start
- Whenever power comes after interruption a Time Dealy is provide for turning the unit ON. This safeguards both WLC - Water level Controller and also the water pump.
- SLAS – Simple Level Adjustable Sensor
- NC - Non-corrosive long-life sensors
- AMAHP – Any Motor& Any HP
To know more please contact us or...